Wahl CLIP `N TRIM Instructions Manual - Disposal

Page of 16

Download

Print this page

Bookmark us

CLIP `N TRIM INSTRUCTIONS

be coiled and the unit placed in original box or storage case. Do not

change the plug in anyway.

POWER SCREW (Fig. 5)

Your clipper has a power screw and it has been adjusted for peak

efficiency before leaving the factory. However, if your voltage in

your home is low, you may need to adjust it.

To adjust, turn your clipper to ON. Use the end of the cleaning

brush, a screw driver or coin to turn the power screw in a clockwise

direction until you hear a noise. Then slowly turn the power screw

out (counter clockwise), just until noise stops and then an additional

half turn. This is the maximum power setting.

DISPOSAL

Handle with care! Environmental damage in the case of incor-

rect disposal.

Correct disposal will ensure environmental protection and prevent any

potentially harmful impacts on people and the environment.

Adhere to the relevant legal requirements when disposing of the appliance.

Information on the disposal of electrical and electronic appliances in the

European Community:

Within the European Community, national regulations are

specified for the disposal of electrical appliances, based on EU

Waste Electrical and Electronic Equipment Directive 2002/96/EC

(WEEE). In accordance with this, the appliance can no longer be

disposed of with the local or domestic waste.

The appliance will be accepted free of charge by local collection

points or recycling centres.

« ‹ Prev 10 11 12 13 14 15 16 Next › »

Summary of CLIP `N TRIM

Page 1
1 clip `n trim instructions clip `n trim instructions.
Page 2: Contents
2 clip `n trim instructions contents general user information page 3 important safeguards page 4 operating instructions page 8 care and cleaning page 12 disposal page 13 wiring page 14 product registration page 15 guarantee page 15 please read all instructions carefully to familiarise yourself with ...
Page 3: General User Information
3 clip `n trim instructions general user information information about using the operation manual ► before using the appliance for the first time, you must read and understand the operation manual completely. ► consider the operation manual as part of the product and store it in a safe and accessibl...
Page 4: Important Safeguards
4 clip `n trim instructions please retain this leaflet for future reference. Read all instructions before using. Important safeguards when using this electrical appliance, especially when children are present, basic safety precautions should always be observed including the following. Requirements ►...
Page 5: Hazards
5 clip `n trim instructions hazards danger! Electric shock due to damage to appliance ► do not operate the appliance with a broken cord, plug or charger, or if the appliance malfunctions, or is dropped or damaged in anyway. ► any servicing or repair must be performed by an authorized service represe...
Page 6
6 clip `n trim instructions off attachments and also before cleaning the appliance. Caution! Danger of product damage ► never use your appliance without paying attention! Always unplug this appliance from the electricity outlet immediately after use. ► do not wrap the cord around the appliance. ► do...
Page 7
7 clip `n trim instructions 2 1 4 3 a b b a b a 5 8 9 7 6 a b.
Page 8: Operating Instructions
8 clip `n trim instructions operating instructions before you cut hair 1.Your clipper should be clean, oiled and in perfect working condition. 2.If your kit includes a plastic cape, place it around the neck, tying the strings and overlapping the cape portion to prevent the hair from falling down ins...
Page 9
9 clip `n trim instructions be positioned between the trimmer lid and detail trimmer guide fingers. • press down on the top centre of the detail trimmer lid and snap on the clipper blade (fig. 6b). Do not push on the detail trimmer blade. 4.Turn the control to the on position and use for detail trim...
Page 10
10 clip `n trim instructions be pointing up but flat against the head. Slowly lift the clipper up and outward through the hair (similar to a rocking motion). 4.Cut only a small amount at a time. 5.Repeat around sides and back of head. 6.For slightly shorter hair, either change to a shorter guide com...
Page 11: Left Ear Taper
11 clip `n trim instructions using left and right ear combs left ear taper 1.Attach the left ear taper comb to your clipper and stand facing the left ear. 2.Hold the clipper at a slight angle against the head. Position the comb just back of the left ear at the hairline. 3.Move the clipper in a small...
Page 12: Care And Cleaning
12 clip `n trim instructions care and cleaning taper lever (fig. 2) your clipper has an adjustable taper lever, it is conveniently located near your thumb (if you are right handed), and so it can easily be adjusted while the clipper is in your hand. The taper lever adds versatility to your clipper b...
Page 13: Disposal
13 clip `n trim instructions be coiled and the unit placed in original box or storage case. Do not change the plug in anyway. Power screw (fig. 5) your clipper has a power screw and it has been adjusted for peak efficiency before leaving the factory. However, if your voltage in your home is low, you...
Page 14: Wiring
14 clip `n trim instructions wiring warning: if the supply cord is damaged it must be replaced by the manufacturers service agent or a similarly qualified person in order to avoid a hazard. The wires in the mains lead are coloured in accordance to the following code: blue neutral (n) brown live (l) ...
Page 15: Product Registration
15 clip `n trim instructions product registration wahl are constantly developing and launching new products in the uk. We would like to understand your product needs and expectations and we value any comments you may have. As part of wahl customer services, we are offering you the chance to be kept ...
Page 16
16 clip `n trim instructions wahl (uk) limited herne bay trade park sea street herne bay kent ct6 8jz. Customer services t: 01227 740066 www.Wahl.Co.Uk form no. Za787 rev4 06-14.